LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> Reno Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (Air Conditioning System) >> Manual >> Repair Instructions >> Compressor Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Compressor Removal

WARNING: This page is about a different car, the 2006 Suzuki Verona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Discharge and recover the refrigerant. Refer to Discharging, Adding Oil, Evacuating and Charging Procedures for A/C System .
  3. Remove the discharge hose mounting nut.
  4. Lift the discharge hose mounting block and the suction hose from the compressor.
    Fig 1: Identifying Compressor Hose Connecting Block & Nut
    G04718908Courtesy of SUZUKI OF AMERICA CORP.
  5. Raise and suitably support the vehicle.
  6. Disconnect the electrical connector at the compressor.
  7. Remove the drive belt and the idler pulley. Refer to SERPENTINE ACCESSORY DRIVE BELT REMOVAL .
  8. Remove the front and the rear compressor-to-bracket bolts.
    Fig 2: Identifying Front And Rear Compressor-To-Bracket Bolts
    G04720019Courtesy of SUZUKI OF AMERICA CORP.
  9. Remove the compressor.
  10. Drain the oil from the compressor into a container. Measure the amount of the oil that is drained. Then discard the used oil.
scientia non olet · About LEMON Manuals