Front Wheel Speed Sensor Removal and Installation: Installation

WARNING: This page is about a different car, the 2007 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.

Reference: FRONT AND REAR WHEEL SPEED SENSOR INSPECTION

Check that no foreign material is attached to sensor (1) and wheel speed sensor encoder (included in wheel hub assembly).
Install it by reversing removal procedure.
NOTE: Before fitting wheel speed sensor, be sure to silicon grease to its O-ring.

Tightening torque

Front wheel speed sensor bolt a: 11 N.m (1.1 kg-m, 8.0 lb-ft)

Front wheel speed sensor harness clamp bolt b: 11 N.m (1.1 kg-m, 8.0 lb-ft)
Check that there is no clearance between sensor and knuckle.

Fig 1: Identifying Clearance Between Sensor And Knuckle
Courtesy of SUZUKI OF AMERICA CORP.