Intake Manifold Removal and Installation: Installation
WARNING: This page is about a different car, the 2007 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
Reverse removal procedure for installation noting the followings.
- Use new intake manifold O-ring.
- Install intake manifold bolts (2) and nuts (1) as shown in Fig 1.
Apply thread lock cement to intake manifold bolt.
"A": Thread lock cement 99000-32110Thread Lock Cement Super 1322 ()
- Check to ensure that all removed parts are back in place.
Reinstall any necessary parts which have not been reinstalled.
- Refill cooling system, referring to COOLING SYSTEM FLUSH AND REFILL .
- Upon completion of installation, turn ignition switch ON but engine OFF and check for fuel leaks.
- Finally, start engine and check for engine coolant leaks.