DTC Check

WARNING: This page is about a different car, the 2007 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: To know how to use SUZUKI scan tool in detail, refer to its operator's manual.

Turn the ignition switch to OFF position.
Connect SUZUKI scan tool to data link connector (DLC) (1) located under instrument panel at driver's seat side.
Special Tool

(A): SUZUKI scan tool (SUZUKI-SDT)

Fig 1: Connecting SUZUKI Scan Tool To Data Link Connector
Courtesy of SUZUKI OF AMERICA CORP.
Turn the ignition switch to ON position.
Read DTC according to instructions displayed on SUZUKI scan tool and print them or write them down. Refer to scan tool operator's manual for details.
If communication between scan tool and ECM is not possible, go to TROUBLESHOOTING FOR COMMUNICATION ERROR WITH SCAN TOOL USING CAN .
After completing the check, turn ignition switch to OFF position, and then disconnect SUZUKI scan tool from DLC.