DTC Confirmation Procedure
WARNING: This page is about a different car, the 2007 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Check to make sure that the following conditions are satisfied when using this "DTC Confirmation Procedure".
EVAP leak check model:
EVAP leak check model:
- The following DTCs are not detected: DTCs related to A/F sensor heater, ECT sensor and IAT sensor
Non-EVAP-leak-check model:
- The following DTCs are not detected: DTCs related to A/F sensor heater
- With ignition switch OFF, connect scan tool to DLC.
- Turn ON ignition switch and clear DTC.
- Start engine and warm up to normal operating temperature.
- Run engine at idle speed for 2 min. or more.
- Check DTC and pending DTC.