DTC Confirmation Procedure
WARNING: This page is about a different car, the 2007 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.
NOTE:
Check to make sure that the following conditions are satisfied when using this "DTC Confirmation Procedure".
EVAP leak check model:
EVAP leak check model:
- Engine coolant temperature at engine start: lower than 30 °C (86 °F)
- The following DTCs are not detected: DTCs related to ECT sensor and IAT sensor (other than P0111)
Non-EVAP-leak-check model:
- Intake air temperature at engine start: -10 °C (14 °F) to 80 °C (176 °F)
- Intake air temperature: -10 °C (14 °F) to 70 °C (158 °F)
- Engine coolant temperature: 70 °C (158 °F) to 150 °C (302 °F)
- Altitude (barometric pressure): 2400 m, 8000 ft or less (560 mmHg, 75 kPa or more)
- The following DTCs are not detected: DTCs related to ECT sensor, IAT sensor (other than P0111) and barometric pressure sensor
- With ignition switch OFF, connect scan tool.
- Turn ON ignition switch, clear DTC.
- Start engine and warm up to normal operating temperature.
- Drive vehicle more than 37 mph (60 km/h) for 15 min.
- Stop vehicle and run engine at idle speed.
- Check DTC and pending DTC.