LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> Reno Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Air Conditioning System) >> Repair Instructions >> Compressor Removal and Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Compressor Removal and Installation: Removal

WARNING: This page is about a different car, the 2005 Suzuki Reno and 2005 Suzuki Forenza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Discharge and recover the refrigerant. Refer to "DISCHARGING, ADDING OIL, EVACUATING, AND CHARGING PROCEDURES FOR A/C SYSTEM :".
  3. Remove the discharge hose mounting nut.
  4. Lift the discharge hose mounting block and the suction hose from the compressor.
    Fig 1: Removing Discharge Hose Mounting Block And Suction Hose From Compressor
    G04104141Courtesy of SUZUKI OF AMERICA CORP.
  5. Raise and suitably support the vehicle.
  6. Remove the engine under cover. Refer to "ENGINE UNDER COVERS REMOVAL AND INSTALLATION :".
  7. Remove the accessory drive belt.
    Fig 2: Removing Accessory Drive Belt
    G04104142Courtesy of SUZUKI OF AMERICA CORP.
  8. Disconnect the electrical connector at the compressor.
  9. Remove the compressor bolts and nuts.
  10. Remove the compressor.
  11. Drain the oil from the compressor into a container. Measure the amount of the oil that is drained. Then discard the used oil.
    Fig 3: Removing Compressor Bolts And Nuts
    G04104143Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals