DTC P2297: HO2S Performance During Decel Fuel Cut-Off (DFCO) Sensor 1: Troubleshooting
TROUBLESHOOTING CHART
| Step | Action | Value (s) | Yes | No |
|---|---|---|---|---|
| 1 | Perform an ON-BOARD DIAGNOSTIC (OBD II) SYSTEM CHECK
. Was the check performed? |
- | Go to Step 2 | Go to ON-BOARD DIAGNOSTIC (OBD II) SYSTEM CHECK |
| 2 |
Any other component related Diagnostic Trouble Codes (DTCs) set? |
- | Go to applicable DTC TABLE | Go to Step 3 |
| 3 |
Is the HO2S1 voltage toggle? |
550 mV | Go to Step 4 | Go to DTC P0134: HO2S Circuit Insufficient Activity Sensor 1 |
| 4 | Check the items in Diagnostic Aids
and repair or replace component as needed. Refer to FUEL SYSTEM DIAGNOSIS
. Is the repair complete? |
- | Go to Step 6 | Go to Step 5 |
| 5 |
Is the repair complete? |
- | Go to Step 6 | - |
| 6 |
Does the scan tool indicate that this diagnostic has run and passed? |
- | Go to Step 7 | Go to Step 2 |
| 7 | Check if any additional DTCs are set. Are any DTCs displayed that have not been diagnosed? |
- | Go to applicable DTC TABLE | System OK |