DTC P0314: Misfire Detected With Camshaft Position (CMP) Sensor Error: Troubleshooting
TROUBLESHOOTING CHART
| Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
| 1 | Perform an On-Board Diagnostic (OBD II) System Check. Was the check performed? | - | Go to Step 2 | Go to On-Board Diagnostic (OBD II) System Check |
| 2 | Observe the scan tool DTC information. Is any of the DTCs P0016 or P0340 set? | - | Go to applicable DTC table | Go to Step 3 |
| 3 | Perform the diagnostic procedure for DTC P0300. Did you find and correct the condition? | - | Go to step 5. | Go to step 4. |
| 4 | Replace the ECM. Is the replace complete? | - | Go to Step 5 | - |
| 5 | 1.Clear the DTCs with a scan tool. 2.Turn the ignition OFF for 30 seconds. 3.Operate the vehicle within the Conditions for Setting the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records. Did the DTC fail this ignition? | - | Go to Step 2 | Go to Step 6 |
| 6 | Check if any additional DTCs are set. Are any DTCs displayed that have not been diagnosed? | - | Go to applicable DTC table | System OK |