Changing the Fluid

Tools Required: 

DW260-070 Plug Remover/Installer 

1. Disconnect the negative battery cable.
2. Raise and suitably support the vehicle.
3. Place a fluid container below the fluid drain plug.
4. Remove the transaxle fluid drain plug using the plug remover/installer DW260-070.
   Fig 1: Identifying Plug Remover/Installer DW260-070

   Courtesy of SUZUKI OF AMERICA CORP.
5. Adding transaxle fluid. Refer to Transaxle Fluid Level Checking Procedure .
6. Install the transaxle fluid drain plug using the plug remover/installer DW260-070.

   Tighten: 

   Tighten the Transaxle Fluid Drain Plug to 45 N.m (33 lb-ft).

7. Connect the negative battery cable.
   Fig 2: Adding Transaxle Fluid

   Courtesy of SUZUKI OF AMERICA CORP.