LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> Reno Automatic >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine - Diagnostic Introduction >> Diagnostic Information & Procedure >> Malfunction Indicator Lamp ON Steady >> Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Malfunction Indicator Lamp ON Steady: Troubleshooting

TROUBLESHOOTING CHART

Step Action Value(s) Yes No
1 Perform an ON-BOARD DIAGNOSTIC (OBD II) SYSTEM CHECK .
Is the check complete?		 - Go to Step 2 Go to On-Board Diagnostic (OBD II) System Check 
2
  1. Turn the ignition switch to LOCK.
  2. Install the scan tool to the Data Link Connector (DLC).
  3. Command the Malfunction Indicator Lamp (MIL) ON and OFF.

Does the MIL turn ON and OFF when commanded?		 - Go to Step 7 Go to Step 3
3
  1. Turn the ignition switch to LOCK.
  2. Disconnect the Engine Control Module (ECM) connector.
  3. Turn the ignition switch to ON.

Is the MIL OFF?		 - Go to Step 6 Go to Step 4
4 Check the MIL control circuit for a short to ground and repair as needed.
Is the repair complete?		 - Go to Step 7 Go to Step 5
5 Replace the instrument panel cluster. Refer to INSTRUMENT PANEL REMOVAL AND INSTALLATION .
Is the repair complete?		 - Go to Step 7 -
6 Replace the ECM.
Is the repair complete?		 - Go to Step 7 -
7
  1. Using the scan tool, clear the Diagnostic Trouble Codes (DTCs).
  2. Attempt to start the engine.

Does the engine start and continue to run?		 - Go to Step 8 Go to Step 1
8
  1. Allow the engine to idle until normal operating temperature is reached.
  2. Check if any DTCs are set.

Are any DTCs displayed that have not been diagnosed?		 - Go to applicable DTC TABLE  System OK
scientia non olet · About LEMON Manuals