Gear Shift Control Lever Rear Case Assembly Removal And Installation: Installation

Install gear shift control lever rear case assembly with its plate to transfer case or extension case referring to figure for proper installing direction of control shaft joint bolt (2). Tighten plate bolts (1) and control shaft joint nut (3) to specified torque.
Tightening torque

Plate bolt a: 23 N.m (2.3 kg-m, 17.0 lb-ft)

Control shaft joint nut b: 18 N.m (1.8 kg-m, 13.0 lb-ft)

Fig 1: Identifying Control Shaft Joint Bolt & Plate
Courtesy of SUZUKI OF AMERICA CORP.
Remount transmission assembly to vehicle referring to MANUAL TRANSMISSION ASSEMBLY DISMOUNTING AND REMOUNTING