April 5, 2026: LEMON Manuals is launched! Read the announcement.

Input Shaft Speed Sensor Removal and Installation: Installation

WARNING: This page is about a different variant/trim than selected.

Check that sensor is free from any metal particles and damage.
Apply A/T fluid to new O-ring and then install input shaft speed sensor (1) to transmission. Tighten sensor bolt to specified torque.
Tightening torque

Input shaft speed sensor bolt a: 5.5 N.m (0.55 kg-m, 4.0 lb-ft)

Fig 1: Identifying Input Shaft Speed Sensor Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Connect input shaft speed sensor connector.
Lower hoist.
Connect negative cable at battery.