Service Manual Update: Front And Rear Wheel Alignment Specification Change (TS 02 08237)

WARNING: This page is about the Grand Vitara Base, AWD, Automatic, which is a different variant/trim than selected.

Publication date: 2013-01-25
Reference number: TS 02 08237

SERVICE MANUAL UPDATE: FRONT AND REAR WHEEL ALIGNMENT SPECIFICATION CHANGE

TECHNICAL SERVICE BULLETIN

Reference Number(s): TS 02 08237, Date of Issue: January 25, 2013

SUZUKI:	2007~2008 GRAND VITARA (JB627)
SECTION:	Suspension

CONDITION

Front and rear wheel alignment toe tolerance specification for each wheel has been changed.

CAUSE

Tolerance change.

CORRECTION

Please update your Service Manual according to attached sheets.

AFFECTED SERVICE MANUAL(S)

AFFECTED SERVICE MANUALS

MANUAL NAME	PART NUMBER	Page(s)	CORRESPONDING SECTION
2007MY Grand Vitara (JB627) Service Manual	99500S66J10-33E	2A-3	Sec.2A: Suspension General Diagnosis "Wheel Alignment Specifications"
2008MY Grand Vitara (JB627) Service Manual	99500S66J20-33E	2A-3

NOTE: These updates will be reflected in future printings of the service manuals. If the reprint date on the inside back cover of the manual is later than the issue date of this bulletin, the manual will have been updated.

Dealership Circulation - Initial and file:

SEC.2A: SUSPENSION GENERAL DIAGNOSIS

Wheel Alignment Specifications

Wheel alignment specifications

Item		Front	Rear
Toe ("b" - "a") (mm) (in.) Toe ("d") (degree) (each wheel)*1		0.0 ± 2.0 (0 ± 0.0787) 0° ± 5'	IN 6.0 ± 2.0 (0.2362 ± 0.0787) 0° 14' ± 5'
Camber "c" (degree)		0° 00' ± 1°	-1° 15' ± 30'
Caster (degree)		2° 30'	-
Side Slip (mm/m) (on one person)*1 (in./3.3 ft)		IN 1.5 to OUT 1.5 IN 0.0591 to OUT 0.0591	IN 7.5 IN 0.2953
Steering angle	Inside	37.0° ± 3°	-
(Turning angle	Outside	32.0° ± 3°	-

NOTE:

Toe value in the specifications table was measured by using a toe-in gauge.
As for front camber and caster, regulation is impossible.

*1: Reference information.