DTC Confirmation Procedure
NOTE:
Check to make sure that the following conditions are satisfied when using this "DTC Confirmation Procedure".
- Intake air temperature: between -10°C and 70°C (14°F and 158°F).
- Engine coolant temperature: higher than 20°C (68°F).
- Atmospheric pressure: higher than 75 kPa (560 mmHg) (Altitude: lower than 2790 m (9150 ft)).
- The following DTC(s) are not detected: fuel system, ECT sensor, barometric pressure sensor, IAT sensor, VSS, MAT sensor, EVAP canister purge valve and APP sensor.
- With ignition switch OFF, connect scan tool.
- Turn ON ignition switch and clear DTC by using scan tool if any.
- Start engine and warm up to normal operating temperature.
- Keep engine at idle speed for 30 sec.
- Check DTC and pending DTC by using scan tool.