LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> Grand Vitara Base, AWD, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Diagnostic Information and Procedures >> DTC P1723: Range Select Switch Malfunction >> DTC Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Troubleshooting

DTC TROUBLESHOOTING TABLE

Step Action YES NO
1  Was "A/T System Check" performed?  Go to Step 2. Go to A/T SYSTEM CHECK .
2  Check "4" position switch circuit 
  1. Disconnect TCM connector with ignition switch OFF.
  2. Check fir proper connection to "4" position switch at "E93-9" and "E93-21" terminals.
  3. If OK, check resistance of switch circuit between terminals "E93-9" and "E93-21" of disconnected harness side TCM connector.

    "4" position switch circuit 

    Shift selector laver to "P", "N" or "D" range: 3.96 - 4.04 kΩ

    Shift selector lever to "R", "4", "3", or "L", range: 0.99 - 1.01 kΩ


Is check result as specified? 		 Intermittent trouble or faulty TCM. Check for intermittent trouble by referring to INTERMITTENT AND POOR CONNECTION INSPECTION . If OK, substitute a known-good TCM and recheck. Go to Step 3.
3  Check "4" position switch 
Check "4" position switch by referring to "4" POSITION SWITCH INSPECTION 
Is check result as specified? 		 Replace "4" position switch. "4" position switch circuit is malfunction.
scientia non olet · About LEMON Manuals