Rack Boot/Tie-Rod Removal And Installation: Installation

Clean threads of both tie-rod and steering gear case (2).
Apply thread lock cement to thread of tie-rod ball nut (1) and then tighten it to specified torque.
"B": Thread lock cement 99000-32100Thread Lock Cement 1305

Tightening torque

Tie-rod ball nut a: 90 N.m (9.0 kg-m, 65.0 lb-ft)

Fig 1: Identifying Tie-Rod Ball Nut
Courtesy of SUZUKI OF AMERICA CORP.
Apply grease to boot inside "A" indicated in the figure.

Fig 2: Applying Grease To Boot Inside
Courtesy of SUZUKI OF AMERICA CORP.
Position boot properly in grooves of gear case and tie-rod. Check to ensure that boot is free from twist and dent.
Clamp boot with clip and wire. Wire should be new and should go around the boot twice.
Pull its both ends together by screwdriver or such and make sure that the wire won't be crossed. Then twist the ends several times, the twisted ends should be bent in the circumferential direction.

Fig 3: Clamping Boot With Clip & Wire
Courtesy of SUZUKI OF AMERICA CORP.
Install tie-rod end lock nut and tie-rod end to tie-rod. Position lock nut to marking (1) made in removal.
NOTE: When tie-rod was replaced, measure length "a" on removed tie-rod and use it on new replacement tie-rod so as to position lock nut properly.

Fig 4: Measuring Length Of Tie Rod
Courtesy of SUZUKI OF AMERICA CORP.
Install steering gear case. Refer to P/S GEAR CASE ASSEMBLY REMOVAL AND INSTALLATION .