Automatic Transmission Assembly Dismounting and Remounting
Automatic Transmission Assembly Dismounting and RemountingDismounting
1. Dismount engine with transmission and transfer.
2. Remove transfer from transmission.
3. Remove engine rear mounting member and rear mounting.
4. Remove exhaust manifold left and right bracket.
5. Remove cooler hose and cooler pipe No.1.
6. Remove drive plate cover, and then remove drive plate bolts by holding crankshaft pulley bolt stationary.
7. Remove Starting Motor.
8. Remove transmission assembly from engine assembly.
Installation
For remounting, reverse dismounting procedure noting the following points.
^ Tighten each bolts and nuts.
^ Tighten drive plate bolt No.1 (1) first and then tighten drive plate bolts No.2 (2).
^ Set each clamp for wiring securely.
^ Fill A/T fluid.
^ Connect battery and check function of engine and transmission.