Cylinder Block Heater Harness (If Equipped) Removal and Installation

Cylinder Block Heater Harness (If Equipped) Removal and Installation
Removal
1) Disconnect cylinder block heater connector (1) from block heater.





2) Unclamp cylinder block heater harness (2) and then remove it.

Installation
1) Connect cylinder block heater connector to block heater.





2) Install clips (1) with open end facing left side and clip (2) with open end facing upward and clamp (7) to body.
3) Fix cylinder block heater harness with clips ((1), (2)) and clamp (7) securely.
4) Fix cylinder block heater harness to engine harness (3) with clamps (4) at white tape parts (5).
5) Check to make sure that harness protector (6) is installed as shown and its open end faces downward.