C1015

DTC C1015 (No. 15): G Sensor Circuit

DTC Detecting Condition
If the signal voltage of G sensor while at a stop does not vary from that while running, this DTC is set.
Therefore, this DTC may be set when a vehicle is lifted up and its wheel(s) is turned. In such case, clear the DTC and check again.

DTC Troubleshooting
1) Ignition switch OFF.
2) Check for proper installation of ABS hydraulic unit / control module assembly.
3) If OK, substitute an ABS hydraulic unit / control module assembly with correct part number.
4) Recheck system.