B1207

DTC B1207: Front Left (Weight) Sensor Crush Detected

CAUTION:
- Be sure to perform Air Bag Diagnostic System Check: Advanced Air Bag before starting diagnosis according to flow.
- When measurement of resistance or voltage is required in this flow, use a tester along with a correct terminal adapter from special tool (Connector test adapter kit).
- When a check for proper connection is required, refer to Inspection of Intermittent and Poor Connections: Advanced Air Bag.
- If there is open circuit in air bag wire harness, connector or terminal is found damaged, replace the wire harness, connector and terminal as an assembly.

DTC Will Set when
When a stress exceeding the specified value is inputted to the FL weight sensor.

Flow Test Description
Step 1: Check for DTC.
Step 2: Check for FL weight sensor.

Step 1-2:

DTC Troubleshooting

NOTE: Upon completion of inspection and repair work, perform the following items.
- Reconnect all air bag system components and ensure all components are properly mounted.
- Clear DTCs referring to DTC Clearance for SDM: Advanced Air Bag and DTC Clearance for OCM: Advanced Air Bag, if any.
- Repeat Air Bag Diagnostic System Check: Advanced Air Bag to confirm that the trouble has been corrected.
- Perform occupant classification system rezeroing referring to Occupant Classification System Rezeroing: Advanced Air Bag.
- Perform occupant classification system sensitivity check referring to Occupant Classification System Sensitivity Check: Advanced Air Bag after system rezeroing.