Front Strut Assembly Removal and Installation: Installation
Reference: FRONT STRUT ASSEMBLY CHECK
Install strut assembly by reversing removal procedure, noting the following instructions.
- Insert bolts in such direction as shown in figure.
- Tighten all fasteners to specified torque.
Tightening torque
Strut bracket nut a: 105 N.m (10.5 kg-m, 76.0 lb-ft)
Strut support nut b: 28 N.m (2.8 kg-m, 20.5 lb-ft)
Brake hose mounting bolt c: 25 N.m (2.5 kg-m, 18.0 lb-ft)
Stabilizer joint nut d: 50 N.m (5.0 kg-m, 36.5 lb-ft)
NOTE:- Don't twist brake hose and ABS wheel speed sensor harness (if equipped) when installing it.
- Install ABS wheel speed sensor harness (if equipped) to strut bracket as shown in figure.
- Tighten wheel nut to specified torque.
Tightening torque
Wheel nut: 85 N.m (8.5 kg-m, 61.5 lb-ft)
- After installation, confirm front wheel alignment.