LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> XL-7 Premium, RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wipers/Washers >> Repair Instructions >> Intermittent Wiper Relay Circuit Inspection >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Intermittent Wiper Relay Circuit Inspection: Notes

  1. Turn the front wiper switch to "INT" position.
  2. Connect battery positive terminal to terminal "B3" and its negative terminal to terminal "EW".
  3. Connect voltmeter positive lead to terminal "L" and its negative lead to terminal "EW".
  4. Check that the voltmeter indicates the battery voltage (10 - 14 V).
  5. Connect terminal "AS" and terminal "B3" for 5 sec. or more by a jumper wire.
  6. Disconnect end of the jumper wire from terminal "B3".
  7. Connect disconnected jumper wire end to terminal "EW", then check that voltage between terminal "L" and terminal "EW" changes as shown in figure.

    If check result is not satisfied, replace.

    Fig 1: Identifying Wiper Relay Circuit
    G04723834Courtesy of SUZUKI OF AMERICA CORP.
    Fig 2: Identifying Wiper Relay Voltage Specification
    G04723835Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals