Rear Door Glass Removal and Installation: Removal

Remove inside handle bezel (1).

Fig 1: Identifying Inside Handle Bezel
Courtesy of SUZUKI OF AMERICA CORP.
Remove inside lock knob and door inside pull handle case fitting screw.
Remove window regulator handle (if equipped). To remove regulator handle, pull off snap ring by using a cloth as shown in the figure.

Fig 2: Pulling Off Snap Ring Using A Cloth
Courtesy of SUZUKI OF AMERICA CORP.
Remove door trim (1) with inside weather-strip. With inside handle bezel (2) tilted as shown in the figure, turn door trim (1) 90° counterclockwise to remove it. And disconnect power window switch lead wire.

Fig 3: Identifying Door Trim And Inside Handle Bezel
Courtesy of SUZUKI OF AMERICA CORP.
Remove door sealing cover.
Remove door outer weather-strip (1).
CAUTION: Using a tape-wrapped putty knife (or tape-wrapped screwdriver), pry off weather-strip. Use of an unwrapped tool will cause damage to painting.

Fig 4: Identifying Door Outer Weather-Strip & Screw
Courtesy of SUZUKI OF AMERICA CORP.
Remove glass fitting screws (2). Then down door glass (1).

Fig 5: Identifying Glass Fitting Screws And Door Glass
Courtesy of SUZUKI OF AMERICA CORP.
Detach rear part of glass run (1) from center sash (2).

Fig 6: Identifying Rear Part Of Glass Run & Center Sash
Courtesy of SUZUKI OF AMERICA CORP.
Remove door center sash (3) (by removing 2 screws (1) with door glass lowered all the way down).
When remove partition glass (2), slide to front to remove it.

Fig 7: Identifying Door Center Sash, Partition Glass And Screws
Courtesy of SUZUKI OF AMERICA CORP.
Take out glass.