LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> XL-7 Base, RWD, Standard >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine General Information And Diagnosis >> Diagnostic Information and Procedures >> DTC P0118: Engine Coolant Temperature Circuit High >> DTC Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Troubleshooting

DTC DIAGNOSTIC TROUBLESHOOTING CHART

Step Action YES NO
1  Was "Engine and Emission Control System Check" performed?  Go to Step 2. Go to ENGINE AND EMISSION CONTROL SYSTEM CHECK .
2  Check ECT sensor and its circuit 
  1. Connect scan tool with ignition switch turned OFF.
  2. Turn ON ignition switch.
  3. Check engine coolant temp. displayed on scan tool.

Is -40 °C (-40 °F) indicated? 		 Go to Step 3. Intermittent trouble. Check for intermittent referring to INTERMITTENT AND POOR CONNECTION INSPECTION .
3  Check wire harness 
  1. Disconnect ECT sensor connector with ignition switch turned OFF.
  2. Check for proper connection to ECT sensor at "GRN" and "GRY/YEL" wire terminals.

If OK, then with ignition switch turned ON, is voltage applied to "GRN" wire terminal about 4 - 6 V? 		 Go to Step 4. Open in "GRN" circuit or shorted to power supply line, or poor "C51-3-2" terminal connection. If wire and connection are OK, substitute a known-good ECM and recheck.
4  Check wire harness 
  1. Using service wire, connect ECT sensor connector terminals.
  2. Turn ON ignition switch and check engine coolant temp. displayed on scan tool.

Is 164 °C (327 °F) indicated? 		 Replace ECT sensor. Open in "GRY/YEL" circuit or poor "C51-3- 25" terminal connection. If wire and connection are OK, substitute a known-good ECM and recheck.
scientia non olet · About LEMON Manuals