LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> XL-7 Base, RWD, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Cruise Control Systems >> Diagnostic Information and Procedures >> Overdrive and TCC off Command Signal Circuit Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Overdrive and TCC off Command Signal Circuit Check

TEST PROCEDURE - OVERDRIVE AND TCC OFF COMMAND SIGNAL CIRCUIT

Step Action YES NO
1  Overdrive OFF command signal circuit check 
  1. Disconnect connector from cruise control module with ignition switch OFF.
  2. Check for proper connection to cruise control module at terminal "E132-3".
  3. If OK, turn ignition switch ON.
  4. Check voltage between terminal "E132-3" and ground.
G04724009Courtesy of SUZUKI OF AMERICA CORP.

Is it 10 -14 V? 		 This signal circuit is OK. Check "PNK/BLU" wire for open and short. If OK, substitute a known-good ECM and recheck.
scientia non olet · About LEMON Manuals