LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> XL-7 Base, RWD, Automatic >> Repair and Diagnosis (Single Page) >> Engine Performance >> Engine Control Systems >> Engine General Information And Diagnosis >> Diagnostic Information and Procedures >> Idle Speed / Idle Air Control (IAC) Duty Inspection >> Using SUZUKI Scan Tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Using SUZUKI Scan Tool

  1. Connect SUZUKI scan tool to DLC with ignition switch OFF.

    Special Tool 

    (A): SUZUKI scan tool 

  2. Warm up engine to normal operating temperature.
  3. Check IAC duty and idle speed by using "Data List" mode of SUZUKI scan tool.

    Engine idle speed 

    A/C OFF: 700 r/min  .

    A/C ON: 750 r/min  .

    IAC duty at specified idle speed 

    5 - 40% (at A/C OFF) 

    Fig 1: Identifying SUZUKI Scan Tool
    G04721066Courtesy of SUZUKI OF AMERICA CORP.
  4. If duty and/or idle speed is out of specifications, check idle air control system referring to DTC P0506 / P0507: Idle Air Control System RPM Lower than Expected / Higher than Expected .
  5. Check that specified engine idle speed is obtained with A/C ON if vehicle is equipped with A/C. If not, check A/C ON signal circuit and idle air control system.
scientia non olet · About LEMON Manuals