LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> XL-7 Base, RWD, Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Warning Systems >> Tire Pressure Monitoring System >> Repair Instructions >> Tire Pressure Sensor On-Vehicle Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Tire Pressure Sensor On-Vehicle Inspection

NOTE: Perform Steps  6 to  7 within 15 minutes after the vehicle was driven. If more than 15 minutes have elapsed after the vehicle was driven, perform Step  5 again.
  1. Turn ignition switch to OFF position.
  2. Connect SUZUKI scan tool to DLC.

    Special Tool 

    (A): SUZUKI scan tool 

    Fig 1: Identifying SUZUKI Scan Tool
    G04724078Courtesy of SUZUKI OF AMERICA CORP.
  3. Check each tire for crack, any other damage and air leakage.
  4. Adjust each tire pressure to 220 kPa.
  5. Drive vehicle at more than 40 km/h (25 MHP) for 2 minutes.
  6. Select "Data List" under TPMS of SUZUKI scan tool.
  7. Check "Sensor status" of each tire pressure sensor indicated in "Data List". It should be "Normal". If "OFF" is indicated, register the ID code of the tire pressure sensor in TPMS control module, referring to REGISTRATION PROCEDURE FOR TIRE PRESSURE SENSOR ID CODE . If "Learn", "Low Battery", "Re-measure" or "Wake" is indicated, replace the tire pressure sensor.
scientia non olet · About LEMON Manuals