LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> XL-7 Base, 4WD, Automatic >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Aux. Emission Control Devices >> Repair Instructions >> EVAP Canister Removal and Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

EVAP Canister Removal and Installation: Removal

  1. Disconnect negative cable at battery.
  2. Hoist vehicle.
  3. Disconnect EVAP leak check module connector.
  4. Disconnect purge hoses (1), tank hose (2) and air suction hose (3) from EVAP canister (4) and air suction pipe (5).

    For quick joint of air suction hose and tank hose, disconnect it as follows:

    1. Remove mud or rust around joint by blowing compressed air, and push joint fully in arrow direction.
    2. Disconnect hose joint while joint lock is unlocked by pushing both sides of joint.
  5. Remove EVAP canister with EVAP leak check module and its bracket (6).
  6. Remove EVAP canister with EVAP leak check module from its bracket.
  7. Remove EVAP leak check module cover (7).
  8. Disconnect air suction hose from EVAP leak check module.
  9. Remove EVAP leak check module from EVAP canister.
    Fig 1: Identifying EVAP Canister Components
    G04721124Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals