Not Using SUZUKI Scan Tool

Perform the driving test referring to "Driving test" under ABS CHECK , if DTC C1015 (DTC 15), C1022 (DTC 22), C1026 (DTC 26), C1032 (DTC 32) or C1036 (DTC 36) is detected.
Turn ignition switch OFF.
Using service wire (4), connect diagnosis switch "PNK" wire terminal (2) of diagnosis monitor coupler (1) to "BLK" wire terminal (3).

Fig 1: Identifying Monitor Coupler, Wire Terminals & Service Wire
Courtesy of SUZUKI OF AMERICA CORP.
With connection described in Step 3 maintained, turn ignition switch ON.
Repeat disconnecting and reconnecting of service wire between diagnosis and ground terminals 5 times or more at about 1 sec. interval within 10 seconds.
NOTE: Service wire ON time must be for 1 second and more.

Fig 2: Identifying Blinking Pattern
Courtesy of SUZUKI OF AMERICA CORP.
Turn ignition switch to OFF position and disconnect service wire from monitor coupler.
Perform the driving test referring to "Driving test" under ABS CHECK and DTC CHECK and confirm that normal DTC (DTC 12) is displayed; not malfunction DTC.