Rear Wheel Speed Sensor Rotor Removal and Installation

Rear Wheel Speed Sensor Rotor Removal and Installation
Reference: Rear Wheel Speed Sensor Rotor On-Vehicle Inspection
Removal
1) Remove rear axle shaft assembly referring to Rear Axle Shaft and Wheel Bearing Removal and Installation.
2) In order to remove sensor rotor (retainer ring) (2) from shaft (1), grind with a grinder two portion (4) of the sensor rotor (retainer ring) as shown till it becomes thin.

CAUTION:
^ Cover vinyl sheet (3) or the like over wheel bearing so that fine grains from grinding will not enter there.
^ Be careful not to go so far as to grind the retainer ring.





3) Break with a chisel (1) the thin ground sensor rotor (retainer ring), and it can be removed.





Installation
1) Press-fit new sensor rotor (retainer ring) (1) as shown in the figure.





2) Install rear axle shaft assembly referring to Rear Axle Shaft and Wheel Bearing Removal and Installation.