Clearing Diagnostic Trouble Codes

DTC Clearance
After repair or replace malfunction part(s), clear all DTCs by performing the following procedure.

Using SUZUKI Scan Tool
1. Connect SUZUKI scan tool to data link connector in the same manner as when making this connection for DTC check.
2. Turn ignition switch ON.
3. Erase DTC according to instructions displayed on scan tool. Refer to scan tool operator's manual for further details.
4. After completing the clearance, turn ignition switch off and disconnect scan tool from data link connector.

Without Using SUZUKI Scan Tool
1. Turn ignition switch OFF.
2. Using service wire (2) , connect diagnosis switch terminal of diagnosis monitor coupler (1) to body ground (3) .




3. With connection described in above Step 2. maintained, turn ignition switch ON.




4. Repeat disconnecting and reconnecting of service wire between diagnosis switch terminal and body ground 5 times or more at about 1 sec. interval within 10 seconds.
5. After completing the clearance, turn ignition switch OFF and disconnect service wire from monitor coupler.