Body Control Systems: Service and Repair
BCM removal and installationRemoval
1. Disconnect negative (-) cable at battery.
2. Remove center lower garnish (1).
3. Remove center garnish mounting screw (1) and then pull off center garnish.
4. Remove harness and controller cover (2).
5. Disconnect BCM connectors and HVAC control module connector from each controller.
6. Remove center garnish (1) with BCM (2) and HVAC control module.
7. Remove BCM from center garnish.
Installation
Reverse removal procedure to install BCM noting the following point.
- When installing center garnish, align rubber bushing (1) with BCM installation hole (2) of instrument panel member (3).