Input Shaft Disassembly and Assembly

Input Shaft Disassembly and Assembly
Reference: Manual Transmission Assembly Dismounting and Remounting
Reference: Manual Transmission Unit Disassembly

Disassembly
Remove circlip of input shaft (1) and pull out bearing (2) with bearing puller (3) and hydraulic press.

CAUTION: Sealed bearing must not be washed. Replace it with new one when required.





Assembly
Reference: Input Shaft Inspection
1. Bring bearing (1) so that its groove for C-ring is in the front of input shaft (2) and press-fit with special tools and hydraulic press.

Special Tool
(A): 09940-51710
(B): 09924-07720
(C): 09924-07710





2. Select circlip (1) that will make thrust clearance of bearing 0.1 mm (0.0039 in) or less and install it.

Circlip thickness specifications

Circlip thickness specifications:

3. Install roller bearing (1) to input shaft (2).