Manual Selector Assembly Removal and Installation
Manual Selector Assembly Removal and InstallationReference: Manual Selector Assembly Components
Removal
1. Disconnect negative cable at battery.
2. Remove front center console box.
3. Disconnect illumination lamp and O/D OFF switch connector.
4. Remove manual selector assembly mounting bolts.
5. Disconnect select cable (1) from manual selector assembly (2) expanding select cable clip (3).
Installation
Reverse removal procedure to install manual selector assembly noting the following instructions.
^ Make sure that select cable clip (3) holds select cable (1) on manual selector assembly (2) securely.
^ Tighten manual selector assembly mounting bolts to specified torque.
Tightening torque
Manual selector assembly mounting bolt: 18 Nm (1.8 kg-m, 13.5 ft. lbs.)
