Rear Wheel Speed Sensor Removal and Installation
Rear Wheel Speed Sensor Removal and InstallationRemoval
Reference: Rear Wheel Speed Sensor Output Voltage Inspection
1) Disconnect negative cable from battery.
2) Hoist vehicle.
3) Disconnect rear wheel speed sensor connector (2) and detach wire harness (1) from vehicle body and rear axle.
4) Remove harness clamps (2) and sensor bolt (1)
5) Remove rear wheel speed sensor from rear axle.
CAUTION:
^ Do not pull wire harness when removing rear wheel speed sensor.
^ Do not cause damage to surface of rear wheel speed sensor and do not allow dust, etc. to enter its installation hole.
Installation
Reference: Rear Wheel Speed Sensor Inspection
1) Check that no foreign material is attached to sensor and rotor.
2) Install it by reversing removal procedure.
CAUTION: Do not pull wire harness or twist more than necessary when installing rear wheel speed sensor.
Tightening torque
Rear wheel speed sensor bolt a: 21 Nm (2.1 kg-m, 15.5 ft. lbs.)
3) Check that there is no clearance between sensor (1) and knuckle.
