Front Wheel Speed Sensor Removal and Installation
Front Wheel Speed Sensor Removal and InstallationRemoval
Reference: Front Wheel Speed Sensor Output Voltage Inspection
1) Disconnect negative cable from battery.
2) Hoist vehicle and remove wheel.
3) Disconnect front wheel speed sensor connector (1).
4) Remove harness clamp and sensor bolts (2) and remove front wheel speed sensor (1) from knuckle.
CAUTION:
^ Do not pull wire harness when removing front wheel speed sensor.
^ Do not cause damage to surface of front wheel speed sensor and do not allow dust, etc. to enter its installation hole.
Installation
Reference: Front Wheel Speed Sensor Inspection
1) Check sensor rotor referring to Front Wheel Speed Sensor Rotor On-Vehicle Inspection.
2) Install it by reversing removal procedure.
CAUTION:
^ Do not pull wire harness or twist more than necessary when installing front wheel speed sensor (1).
^ Fit harness grommet to inner fender securely.
Tightening torque
Front wheel speed sensor harness clamp bolt a: 10 Nm (1.0 kg-m, 7.5 ft. lbs.)
Front wheel speed sensor bolt b: 23 Nm (2.3 kg-m, 17.0 ft. lbs.)
3) Check that there is no clearance between sensor (1) and knuckle.
