Clearing Diagnostic Trouble Codes

To clear DTCs, use the diagnostic scan tool. When a scan tool is not available, DTCs can also be cleared by disconnecting one of the following sources for at least 30 seconds:

CAUTION: Do not clear DTCs unless directed to do so by the service information provided for each diagnostic procedure. When DTCs are cleared, the Freeze Frame and Failure Record data which may help diagnose an intermittent fault will also be erased from memory. If the fault that caused the DTC to be stored into memory has been corrected, the Diagnostic Executive will begin to count the "warm up" cycles with no further faults detected, the DTC will automatically be cleared from the Engine Control Module (ECM) memory.

CAUTION: To prevent system damage, the ignition key must be OFF when disconnecting or reconnecting battery power.

The power source to the control module. Examples: fuse, pigtail at battery ECM connectors, etc.
The negative battery cable. (Disconnecting the negative battery cable will result in the loss of other onboard memory data, such as preset radio tuning.)