LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Verona Luxury >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wipers/Washers >> Diagnostic Information & Procedures >> DTC 22: Front Washer Switch Error >> DTC Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Troubleshooting

DIAGNOSIS REFERENCE CHART - DTC TROUBLESHOOTING

Step Action Value(s) Yes No
1
  1. Install a scan tool.
  2. Turn the ignition ON, with the engine OFF.
  3. With a scan tool, observe the wiper washer switch parameter in the ISU Wiper/Washer data list.

Does the scan tool display inactive?
- Go to Step 2 Go to Step 4
2
  1. Activate the washer switch.
  2. With a scan tool, observe the wiper washer switch parameter.

Does the wiper washer switch parameter change state?
- Go to Step 6 Go to Step 3
3
  1. Inspect the washer pump motor control circuit for an open or short to ground.
  2. Replace Fuse F16 if necessary.

Did you find and correct the condition?
- Go to Step 10 Go to Step 6
4
  1. Turn the ignition OFF.
  2. Disconnect the wiper switch.
  3. Turn the ignition ON, with the engine OFF.
  4. With a scan tool, observe the wiper washer switch parameter.

Does the scan tool display Inactive?
- Go to Step 7 Go to Step 5
5 Test the signal circuit of the washer switch for a short to voltage.
Did you find and correct the condition?
- Go to Step 10 Go to Step 6
6 Inspect for poor connections at the harness connector of the Intelligent Switching Unit (ISU).
Did you find and correct the condition?
- Go to Step 10 Go to Step 8
7 Inspect for poor connections at the harness connector of the wiper switch.
Did you find and correct the condition?
- Go to Step 10 Go to Step 9
8
NOTE: Perform the program procedure for the ISU.
Replace the ISU.Did you complete the replacement?
- Go to Step 10 -
9 Replace the wiper switch.
Did you complete the replacement?
- Go to Step 10 -
10
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.

Does the DTC reset?
- Go to Step 1 System OK