Ignition Switch Keyhole Lamp Installation

Install the ignitions switch keyhole lamp and the bulb.
Install the head amp (IMMO demodulator) with the screw.
Tighten:

Tighten the ignition switch keyhole lamp screw to 1.5 N.m (13 lb-in.).

Fig 1: Identifying Ignition Switch Keyhole Lamp And Bulb
Courtesy of SUZUKI OF AMERICA CORP.
Raise the steering column.
Connect the steering column electrical connector.
Install the nuts and the bolts securing the steering column.
Tighten:
- Tighten the steering column nuts to 22 N.m (16 lb-ft).
- Tighten the steering column bolts to 22 N.m (16 lb-ft).
Install the steering column upper, lower cover.
Tighten:

Tighten the steering column trim cover screws to 2.5 N.m (22 lb-in.).

Fig 2: Identifying Steering Column Upper, Lower Cover
Courtesy of SUZUKI OF AMERICA CORP.
Install the instrument cluster trim panel. Refer to INSTRUMENT CLUSTER TRIM PANEL INSTALLATION .
Install the knee bolster. Refer to DRIVER'S SIDE KNEE BOLSTER INSTALLATION .
Connect the negative battery cable.

Fig 3: Identifying Instrument Cluster Trim Panel & Screws
Courtesy of SUZUKI OF AMERICA CORP.