LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Verona Base >> Repair and Diagnosis >> Transmission >> Automatic Transmission >> Diagnostic Information and Procedures >> Transaxle Fluid Level Service Procedure >> Fluid Level Diagnosis Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fluid Level Diagnosis Procedure

  1. If the vehicle is at operating temperature allow the vehicle to cool down for 2 hours, but no greater than 4 hours. Or if the vehicle is at cool status, start the engine and allow the engine to idle for approximately 5 minutes (825 - 875 rpm), if possible, drive the vehicle for a few kilometers (N - D, N - R, shift until 2 gear). This will allow the transaxle to be within the correct temperature range. Transaxle fluid level should be checked at temperature 20 - 45 °C (68 - 113 °F).
    WARNING: Removal of the fluid filler plug when the transaxle fluid is hot may cause injury if fluid drains from the filler hole.
  2. Switch OFF accessories, especially air conditioner, heater.
  3. With the brake pedal pressed, move the gear shift control lever through the gear ranges, pausing a few seconds in each range. Return the gearshift lever to P (Park). Turn the engine OFF.
  4. Park the vehicle on a hoist, inspection pit or similar raised level surface. The vehicle must be level to obtain a correct fluid level measurement.
  5. Place a fluid container below the fluid filler plug.
  6. Clean all dirt from around the fluid filler plug.

    Remove the fluid filler plug. Clean the filler plug and check that there is no damage to the "O" ring.

    • If fluid drains through the filler hole the transaxle may have been overfilled. When the fluid stops draining the fluid level is correct. Install the fluid filler plug and tighten it to 45 N.m (34 lb-ft).
    • If fluid does not drain through the filler hole, the transaxle fluid level may be low. Lower the vehicle, and start the vehicle in P (Park) with the parking brake and the brake applied. With the engine idling, move the gear shift lever through the gear ranges, pausing a few seconds in each range and adding the fluid until gear application is felt. Return the gear shift lever to P (Park). Turn the engine OFF and raise the vehicle. Check if the fluid level is aligned with the bottom of the filler hole. If not, add a small quantity of fluid to the correct level. Install the fluid filler plug and tighten it to 45 N.m (34 lb-ft).
  7. When the fluid level checking procedure is completed, wipe any fluid around the filler plug with a rag or shop towel.
scientia non olet · About LEMON Manuals