DTC Troubleshooting

TEST PROCEDURE - SOLENOID 2 OUTPUT OPEN

Step	Action	Value(s)	Yes	No
1	Perform an On-Board Diagnostic (OBD II) System Check. Is the check completed?	-	Go to Step 2	Go to ON-BOARD DIAGNOSTIC (OBD II) SYSTEM CHECK .
2	Install the scan tool. Turn the ignition ON, with the engine OFF. Select "Actuating" on the scan tool. Actuate solenoid 2 ON/OFF. Does the solenoid 2 change ON/OFF?	ON/OFF	Go to Diagnostic Aids .	Go to Step 3
3	Turn the ignition OFF. Disconnect the transaxle wiring connector. Measure the resistance between terminals 3 and 12 of the transaxle wiring connector. Is the resistance within the values shown?	TFT 25 °C (77 °F) 6 Ω	Go to Step 7	Go to Step 4
4	Remove the oil pan. Disconnect the wiring connector of solenoid 2. Measure the resistance between terminal 1 of solenoid 2 and terminal 13 of the transaxle connector. Measure the resistance between terminal 2 of solenoid 2 and terminal 3 of the transaxle connector. Is the resistance within the values shown?	≈ 0 Ω	Go to Step 6	Go to Step 5
5	Repair the line (between terminal 1 and terminal 13) for an open. Repair the line (between terminal 2 and terminal 3) for an open. Is the repair complete?	-	System OK	-
6	Replace the solenoid 2. Is the replacement complete?	-	System OK	-
7	Disconnect the transaxle wiring connector and TCM connector. Measure the resistance between terminal 3 of the transaxle wiring connector and terminal C8 of the TCM wiring connector. Measure the resistance between terminal 13 of the transaxle wiring connector and terminal A9 of the TCM wiring connector. Is the resistance within the values shown?	≈ 0 Ω	Go to Step 9	Go to Step 8
8	Repair the transaxle wiring harness for an open. Is the repair complete?	-	System OK	-
9	Replace the TCM. Is the replacement complete?	-	Go to Step 10	-
10	After the repair, use a scan tool "clear info" function and road test the vehicle. Review the "DTC info". Has the last test failed or is the current DTC displayed?	-	Begin diagnosis again.	Repair verified exit DTC chart.