DTC Troubleshooting

TEST PROCEDURE - BRAKE SWITCH CIRCUIT MALFUNCTION

Step	Action	Value (s)	Yes	No
1	Perform an On-Board Diagnostic (OBD II) System Check. Is the check completed?	-	Go to Step 2	Go to ON-BOARD DIAGNOSTIC (OBD II) SYSTEM CHECK .
2	Install the scan tool. Turn the ignition ON. With the engine OFF. Record then clear DTC(s) Select scan tool's transaxle data display. Disconnect the brake switch connector. Did the brake switch status change from "ON" to "OFF"?	-	Go to Step 3	Go to Step 4
3	Replace the brake switch. Refer to Brake Replacement. After the ignition OFF, turn ignition ON. Is the DTC reset?	-	Go to Step 4	Go to Step 15
4	Inspect the Ef19. Is the fuse blown?	-	Go to Step 5	Go to Step 6
5	Replace the fuse. Is the action complete?	-	System OK	-
6	Turn the ignition OFF. Disconnect the C102 wiring connector and the brake switch wiring connector. Measure the resistance between the terminal D5 of the C102 connector and the terminal 2 of the brake switch wiring connector. Is the resistance within the values shown?	≈ 0 Ω	Go to Step 8	Go to Step 7
7	Repair the open circuit between the C102 connector and the brake switch connector. Is the action complete?	-	System OK	-
8	Turn the ignition ON. Measure the voltage of the C102 connector, D5 terminal. Is the voltage within the values shown?	11 - 14 V	Go to Step 9	Go to Step 10
9	Repair the short to power between the C102 connector and the brake switch connector. Is the action complete?	-	System OK	-
10	Turn the ignition OFF. Disconnect the brake switch wiring connector and TCM wiring connector. Measure between the brake switch connector, terminal 4 and TCM connector, terminal A5. Is the resistance within the values shown?	≈ 0 Ω	System OK	Go to Step 11
11	Repair the open or short to ground between brake switch connector and TCM. Is the action complete?	-	System OK	-
12	Turn the ignition ON. Measure the voltage of the brake switch wiring connector, terminal 2. Is the voltage within the values shown?	11 - 14 V	Go to Step 13	Go to Step 14
13	Repair the short to power between the brake switch wiring connector and TCM. Is the action complete?	-	System OK	-
14	Replace the TCM. Is the action complete?	-	Go to Step 15	-
15	After the repair, use a scan tool "clear info" function and road test the vehicle. Review the "DTC info". Has the last test failed or is the current DTC displayed?	-	Begin diagnosis again.	Repair verified exit DTC chart.