LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Verona Base >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Front Suspension >> Repair Instructions >> Control Arm Bushings Assembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Control Arm Bushings Assembly

  1. Coat the control arm rear shaft with a multipurpose lubricant. Refer to RECOMMENDED FLUIDS AND LUBRICANTS .
  2. Press the control arm front bushing into the control arm using a press, the remover/installer KM-508-A and the removal plate KM-307-B. Center the bushing.
    Fig 1: Pressing Control Arm Front Bushing Into Control Arm
    G04719251Courtesy of SUZUKI OF AMERICA CORP.
  3. Coat the outside of the control arm front bushing and the inside of the control arm with a multipurpose lubricant. Refer to RECOMMENDED FLUIDS AND LUBRICANTS .
  4. Press the control arm front bushing into the control arm using a press, the remover/installer KM-508-A, and the removal plate KM-307-B. Center the bushing.
  5. Install the control arm. Refer to Control Arm Installation .
    Fig 2: Identifying Control Arm, Remover/Installer & Removal Plate
    G04719252Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals