Control Assembly Knob Lighting Installation
- Install the bulb into the holder and turn the bulb to the right.
- Install the control assembly case halves.
- Pass the connector for the vacuum switch through the hole in the rear assembly case part.
- Be sure to align the flats on mating control shafts of the 2 case halves.
- Install the connector into the vacuum control switch.
Courtesy of SUZUKI OF AMERICA CORP.
- Install the control assembly. Refer to Control Assembly Installation .
- Connect the negative battery cable.
- Check the knob light for proper operation.
Courtesy of SUZUKI OF AMERICA CORP.