Rear-End Door / Rear-End Gate Lock Assembly Removal and Installation: Removal

WARNING: This page is about a different car, the 2006 Suzuki XL-7. However, it is still accessible from the selected car via links, so may be relevant.

Remove inside handle bezel (1) (if equipped).

Fig 1: Removing Inside Handle Bezel
Courtesy of SUZUKI OF AMERICA CORP.
Remove inside lock knob.
Remove door trim (1).
With inside handle bezel tilted as shown in figure, turn door trim 90° counterclockwise to remove it.

Fig 2: Identifying Door Trim
Courtesy of SUZUKI OF AMERICA CORP.
Remove rear-end door / rear-end gate sealing cover.
Remove rear-end door / rear-end gate lock control rod (1).
Unlock rear-end door / rear-end gate lock rod pin retainer and disconnect control rod.
Disconnect rear-end door lock motor lead wire.
Remove lock assembly.

Fig 3: Identifying Rear-End Door / Rear-End Gate Lock Control Rod
Courtesy of SUZUKI OF AMERICA CORP.