Passenger Air Bag (Inflator) Module Inspection

WARNING: This page is about a different car, the 2006 Suzuki XL-7. However, it is still accessible from the selected car via links, so may be relevant.

Reference: PASSENGER AIR BAG (INFLATOR) MODULE REMOVAL AND INSTALLATION

WARNING:

Never measure resistance of passenger air bag (inflator) module or disassemble it. Otherwise personal injury may result.
Never attempt to disassemble or repair the passenger air bag (inflator) module. If any abnormality is found, be sure to replace it with new one as an assembly.
Be sure to read PRECAUTIONS ON SERVICE AND DIAGNOSIS OF AIR BAG SYSTEM , Precautions on Handling and Storage of Air Bag System Components and Precautions on Disposal of Air Bag and Seat Belt Pretensioner before starting to work and observe every precaution during work. Neglecting them may result in personal injury or undeployment of the air bag when necessary.

Fig 1: Precautions For Not Measuring Resistance Of Passenger Air Bag Module
Courtesy of SUZUKI OF AMERICA CORP.

CAUTION: If air bag (Inflator) module was dropped from a height or 90 cm (3 ft) or more, it should be replaced.

Check air bag (inflator) module appearance visually for the following symptoms and if any one of them is applicable, replace with a new one.

Air bag has deployed.
There is a crack in trim cover (pad surface).
Wire harness or connector is damaged.
Air bag (inflator) module is damaged or a strong impact (e.g., dropping) was applied to it.