LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Verona Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Air Bag System) >> Diagnostic Information and Procedures >> DTC Clearance for SDM >> Using SUZUKI Scan Tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Using SUZUKI Scan Tool

WARNING: This page is about a different car, the 2006 Suzuki XL-7. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch to OFF position.
  2. Connect SUZUKI scan tool to data link connector (DLC) in the same manner as when making this connection for DTC check.

    Special Tool 

    (A): SUZUKI scan tool 

    Fig 1: Identifying SUZUKI Scan Tool
    G04723532Courtesy of SUZUKI OF AMERICA CORP.
  3. Turn ignition switch to ON position.
  4. Erase DTC according to instructions displayed on SUZUKI scan tool. Refer to SUZUKI scan tool operator's manual for further details.
  5. After completing the check, turn ignition switch to OFF position and disconnect SUZUKI scan tool from DLC.
  6. Perform DTC CHECK FOR SDM  and confirm that normal DTC (NO CODES) is displayed and not malfunction DTC.
    NOTE: If DTC B1013 or DTC B1021 is stored in SDM, it is not possible to clear DTC.
scientia non olet · About LEMON Manuals