LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Verona Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Air Bag System) >> Diagnostic Information and Procedures >> DTC Check for SDM >> Using SUZUKI Scan Tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Using SUZUKI Scan Tool

WARNING: This page is about a different car, the 2006 Suzuki XL-7. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch to OFF position.
  2. Connect SUZUKI scan tool to data link connector (DLC) located on underside of instrument panel at driver's seat side.

    Special Tool 

    (A): SUZUKI scan tool 

  3. Turn ignition switch to ON position.
  4. Read DTC according to instructions displayed on SUZUKI scan tool and print it or write it down. Refer to SUZUKI scan tool operator's manual for further details.

    If communication between scan tool and SDM is not possible, proceed to SDM CANNOT COMMUNICATE THROUGH THE SERIAL DATA CIRCUIT .

  5. After completing the check, turn ignition switch to OFF position and disconnect SUZUKI scan tool from data link connector (DLC).
    Fig 1: Identifying SUZUKI Scan Tool
    G04723528Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals