Continuity check
WARNING: This page is about a different car, the 2006 Suzuki XL-7. However, it is still accessible from the selected car via links, so may be relevant.
- Measure resistance between connector terminals at both ends of the circuit being checked (between "A-1" and "C-1" in the figure).
If no continuity is indicated (infinity or over limit), that means that the circuit is open between terminals "A-1" and "C-1".
- Disconnect the connector included in the circuit (connector-B in the figure) and measure resistance between terminals "A-1" and "B-1".
If no continuity is indicated, that means that the circuit is open between terminals "A-1" and "B-1". If continuity is indicated, there is an open circuit between terminals "B-1" and "C-1" or an abnormality in connector-B.